Z Automotive Z-TZR-JLM Tazer JL Mini Programmer for 18-23 Jeep Wrangler JL & Gladiator JT (2024)

Tazer JL Mini Programmer

Essential Customizing Tool: This powerful yet intuitive module allows unmatched controllability over the features your Jeep is equipped so you can truly personalize your JL Wrangler’s amenities.

User-Friendly : With it’s easy plug and play install along with simple user control using your Jeep’s steering wheel controls, avoid costly dealer intervention when you outfit your Wrangler for adventure.

Advanced Lighting Options & Functionality: The light show mode is perfect for show jeeps and emergency vehicle conversions by allowing preset and customizable light arrays. Drivers can also modify Daytime Running Light (DRL) and factory fog light options the way you wish, and aftermarket LED conversions are supported.

Features Perfect for Off-Roading: Advanced control over your JL’s TPMS system, sway bar and axle features for Rubicon’s, along with sophisticated steering and braking options make this a must-have for the jamboree and trail running community.

Vehicle Setting Features

• Change Tire Size
• Change Gear Ratio
• Change Transfer case LOW ratio
• Enable/Disable TPMS system
• Change TPMS pressure warning limit front/rear (25psi - 85psi)
• Enable/Disable Backup camera
• Enable/Disable Cargo Camera input (8.4 Uconnect only)*
• Enable/Disable CD (wired audio) input*
• Enable/Disable TravelLink/XM traffic&weather
• Change Daytime Running Lights (DRL) region (type)
• Change DRL location
• Enable/Disable DRL Dropout function
• Enable/Disable factory fog lights
• Enable/Disable Fog Light Dropout (when Fogs shut off while High Beams are on)
• Enable/Disable Factory Halo lights (including BCM output for adding Halo’s)
• Enable/Disable Onetouch lane change
• Change Headlight type (std/LED)
• Change Fog light type (std/LED)
• Change Taillight type (std/LED)
• Change Front Turn Signal type (std/LED) supports aftermarket LED lights too
• Enable/Disable Trailer Tow setting
• Enable/Disable Aux Button settings
• Enable/Disable Blind Spot detection (if hardware added or removed)
• Enable/Disable/Change Parksense configuration
• Disable Electronic Sway Bar (if removed from vehicle)
• Disable Front Axle Disconnect module for axle swaps
• Disable Front and Rear Lockers for axle swaps
• Disable Electronic Steering Pump for hydraulic steering conversions
• Change cluster splash screen Wrangler/Sahara/Rubicon
• Change HVAC controls setting to allow use of dual zone controls on single zone Jeep (for those upgrading the 5″ radio)
• Enables use of Factory Anti-Locking Brake System to lock the rear inner wheel while making tight turns on the trail

Live Functions (Only While Plugged In)

• AutoStopStart disable : remembers last state of the auto stop start system and will set it foryou the next time you start the vehicle
• AutoTracKill : remembers last state of traction control system and will set it for you the nexttime you start the vehicle
• Can disconnect sway bar in 2WD up to 30mph (any speed if button mapped SwayKill is used)
• Can use backup camera and added cargo/front/undercarriage camera or media player atany speed
• TurnCAM : automatic backup camera when turn signals are used (8.4 uconnect only)
• Dark Mode : Turns off all exterior lighting and dash/radio/shifter lights while parked withengine running.
• 3rd Brake Flash : Set rate and number of flashes to pulse the 3rd brake light when brakes are applied for increased visibility
• Light Show mode : 6 preset and 3 make-your-own Light shows that flashes all the exteriorlights, perfect for car shows/first responders/off-road visibility. Control from Key Fob orsteering wheel buttons. Can be enabled for in-motion use for parades, off-road and legalpolice/EMS.
• Axle Locker control (Rubicon) : Engage lockers in 2WD and 4Hi on demand.
• TC Kill : Turns off traction control, stability control and ABS.
• Hood Alarm : When the vehicle theft alarm is armed, monitors hood activity and will soundthe alarm and flash light shows if opened.
• Cooldown mode : Turn engine fans on demand when the ignition is on, engine not running
• Line Lock : Can lock front brakes for an easy burnout
• Rock Crawl : Can lock all four brakes by pressing steering wheel buttons to hold the vehiclestill, especially helpful when off-road.
• Winch Mode : Raise idle to 2000 RPM with a simple button press.
• Button Mapping : Use cruise up, down and right buttons as quick-access to some of TazerJL’s functions, when cruise control is off.
• Display DTC’s : Shows the diagnostic codes that’s making the check engine light come on.
• Clear CELs : Reset that pesky check engine light. Good when you have mods that set thelight and you know exactly why.
• 0 to 30 and 0 to 60 Timers : Displays 0-30 or 0-60 times on EVIC display
• Automatically blanks license plate lights when in Reverse on Gladiators, to remove glare on the backup camera at night.
• Vacuum/Boost gauge : Watch real-time Manifold Pressure, great for boosted/turbo applications
• Firmware updates : The new firmware is available periodically, always free!

Note: Many features are intended for off-road use only, and check your state's local regulations as it pertains to lighting usage.

Impersonating a police officer is a felony. light show mode is intended for show and offroad use only. Always consult local regulations regarding your vehicle lighting.

• Read all 36 reviews
• Submit your own Review

• Read all 26 questions
• Have a question? Ask us

Review Summary

Shared Media

Questions